Nothing in E Mode

[BlackVCG]

If that wire is brown, that's not a good sign. It's the wire that goes to the center leg (3 legs) of the transistor at the top of the board, correct?

About the only thing that goes wrong with the E-Mag board is that chip burning out.

If I-Feed doesn't work either, then it sounds like it's a problem with the output of the board, not just the solenoid.

[Halliday]

I had a "dead in E mode" E-Mag last week too. The LED worked fine, and shots counted up, but no shooting action was happening.

I had a dead battery too. It worked most of the day in Hybrid, but when I got home I noticed the "low batt" signal. I charged mine and it's fine now. Hope you figure out your problem.

[BajaBoy]

still no luck?

[~WarpedRT#2~]

Nope, no luck. Yeah, it's the wire on the center leg of that chip. Do i need a new board?? I am happy with the fact that I can still use it like a normal RT, I just want some sort of guarntee that if I get a new board, it will work like it's supposed to. Any sudgestions, or even offers to sell a board to me?

Black, what do you think??

[Cyberious]

A new board will run you about 250 bucks. Plus you still have to solder it in. I emailed you a note regarding this let me know.