converting to rtpro

[tmnothing]

Alright currently I have an AM/MM rail on my ULE mag and I was thinking of converting the ULE mag to an RTPro setup so the foregrip is a little farther forward. If I buy the RTPro rail, foregrip mount, and foregrip (which I havn't found in the AGD store yet) I understand that I will need to buy an RTPro on/off assembly (for my x-valve) but I need to know if there's anything else I'm going to have to buy in order for it to work.

[Dave]

I'm pretty sure the only other thing you are going to need is the RT Pro sear assembly and sear pin...it has a screw in like the Emag.

-Dave

[tmnothing]

would i need a new sear assembly or could I use the one that came with the x-valve?

[JadedT]

RTP rail upgrade

You will need a new sear and the sear pin is screwed into the RTP rail, unlike the dropped in pin for AM/ MM rails. I believe the twistlock is slightly longer too than my AM/ MM rails' but it should not matter especially if you get an ULE body.

J.