Level 10 shooting 230-310 fps

[MacMag]

[Dayspring]

Chronoing an RT/X-Valve requires a specific procedure. Are you following this?

And for the leak down the barrel, when it does that, you go to a SMALLER carrier using the SAME oring. It's the oring breaking in. You went the opposite direction. with the level 10, friction is a GOOD thing. It's how the system works.

[MacMag]

Ok I will rememder that friction is good, but any ideas on my FPS consistency issue? Thanks.

[Dayspring]

If you're not following the RT Chrono procedure, your velocity will seem to be erratic.

[AlabamaMan]

How long have you had the valve?

There could be some dirt on the reg piston, explaining erratic velocities.

[MacMag]

Ok this is the how to as per the F&Q @ AGD(below). I have tryed this some what, but will give it a better shot know that I have read it 100 times. I would take it that I would adjust my velocity only at the time between/after the quick fire. I would not adjust after just shooting a few balls? After I set my velocity to rapid fire I would assume my velocity at a slow rate would be lower, and in hand might through off the the leval 10???? But still even not chronographing to this would not seem to be why I am going from 230-310fps. I could see a 10-20fps change but not a 90fps difference.



"Set the pressure going into the RT to 700 psi.
To record your highest rapid fire velocity:-
Fire a paintball and hold the trigger back.
Then release the trigger completely, and fire the next paintball as quickly as possible, once again holding the trigger back.
Repeat as necessary. "

The X-valve and levelX is new 2000 + balls. I would not think it is dirty.


More than likely this why NASA rejected me!!!lol.

[Havoc_online]

check your nubbins.

[Mav D MagMan]

Ok guys, how would you explain the exact same problem on a Classic valve?

It wasn't as extreme, but I either had to run itaround 230s+ or when I turned it up it jumped to 300+

Thanks!
Mav

(BTW brand new nubbin and reg seats!)