intelli to warp problem.

[TKOMag123]

alright i just got my warp today (used) and i installed the battery, and when i pushed the white button on the side it spun, but when i ltet go it stoped. so i didnt' sweat it. so i installed the warp to intelli mod and now when i plug in the phone jack thing it just spins and doesn stop until i pull the lug out. and it still spins when i push the button. if i hold the button it keeps spinning...HELP ME!!

[ChucktheMAGician]

I'm pretty sure you just need to add/adjust some of the jumpers. I'll look for a link to the thread w/ directions.

ta-daaaa http://www.automags.org/forums/showt...threadid=50487

Might wanna download the manual too.

[ChucktheMAGician]

Me again, Star_Base_CGI http://www.automags.org/forums/showt...threadid=85871 just posted a good pic of the board w/ where you need the jumpers, if that is the problem?! Good luck

[Star_Base_CGI]

Take a look at your positive and Negative jumpers.

The warp feed needs a postive or negative signal from the intelicable to activate. Depedning on how its wired.

[TKOMag123]

thanks guys, i had the jumpers near the sensitivity setting so that there was one, then a space, then another. they were both going horizontaly, guess i just have to move the bottom one so that it's vertical. from what it looks like in the pic above. i'm at school right now and can't chech the jumpers, but i will have to check the jumpers on the left side also. thanks for the help. i will post when i get home to see if i can get it to work.

[Star_Base_CGI]

You dont really need the external sensor on or have to adjust the potentiometer. Thats for guns without electro.

You can hang that jumper off the side of something.

If the intelicable thing doesnt work though. You can always use that.

[Clockwork_Orange]

intelli to warp problem...

What's up TKOMag123,

All you need are three jumpers in the warp. One sitting horizontally on the negative portion of the sensor and two sitting vertically on the dwell timing (it doesn't matter were in the dwell). You want to have only two jumpers in the dwell, so that you do not burn out the motor with excessive spining of the wheel after the trigger is pulled,(the dwell controls the amount of spin)two jumpers work best for me. As for the constant spinning on your warp when you plug in...just seperate the wires a little bit that are connected to the jack that plugs into the warp; you most likely have your wires twisted together to tight, so they're touching each other!

Upgrade your grey matter 'cause 1 day it may matter!!!

[Clockwork_Orange]

Oh, and turn off the sensitivity adjuster you won't need it! Upgrade your grey matter 'cause 1 day it may matter!!!

[Clockwork_Orange]

Sorry, in my first reply I meant to say horizontally on the positive portion of the sensor.






"Upgrade your grey matter 'cause 1 day it may matter!!!"