Warping a shocker and how do I do it

[Tex55]

Ok here goes...I picked up a Warp and I do love the thing, BUT the problem I have is that my sensitivity switch is broke...My warp will run all the time. What I was wondering about is is there away I can hook this up to my marker so that it will cycle while I fire ( I know it works on a IFrame). I guess I should say what I am using is a Shocker SF with a Evolution2. If anyone is able to help me out plz post.

Thanks

Tex

[XVFrontplayer]

well there are three things you can do.

1... you can go to your local proshop and they can hook up your shocker board to an intellifeed wire. in this case they will have to do some soldering and then you plug the other end of the wire(little jak looking deally)into thehole at the bottom of your warp next to the white button

2.. you can buy an external sensor. (i think proteam makes one.

3.. you can move the jumpers around on the part of the board where there are 4 jumpers.(consult your warp manual)