X-valve for Micro E-mag Problem

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • sherminator
    Registered User
    • May 2001
    • 28
    #1

    X-valve for Micro E-mag Problem

    I just got my x-valve in and installed it in my Micro E-mag. At first I did not change the on/off assembly from the old valve to the new x-valve and the marker shot fine. But, when I changed the on/off assembly like the instructions say for the E-mag, the marker went into rapid fire shoot down.

    Is there a problem with the Micro E-mag when changing the on/off? or should I just keep the new on/off assembly in the x-valve?
    2K2 Dust Fly Angel
    68, 4500 NitroDuck X-stream
    EVIL Pipe System
    HALO B
    Tags: None
    • Tunaman
      Specialized AGD Tech

      • Dec 2000
      • 8643
      #2
      So you are saying that your micro emag shot fine with the stock Xvalve .750 pin? If so...I give up on these Micromags...
      Could you please do me a favor and measure the pin in the Emicro on/off that was originally in your working gun?
      Email me for low prices on ALL AGD Products and more. [email protected]
      Tunamart

        Comment

        • sherminator
          Registered User
          • May 2001
          • 28
          #3
          No problem.

          The pin is 0.5 inches
          2K2 Dust Fly Angel
          68, 4500 NitroDuck X-stream
          EVIL Pipe System
          HALO B

            Comment

            Previous template Next
            Working...