-
______________________________
Until then, ride the big one!
______________________________ -
the way the hyper frame works is there is no return spring for the noid so it uses the mags on/off to substitute for that if you wanna check out the frame to see if it works pull your valve out (if your not sure on how to do this consult here again and they will step you through it.
but take and push your finger over the rear part of the sear and pull the trigger it should click and then click again (or as many times as you pull the triggerMY SIG RULZ
GOOD TRADERS: openboater, muirtach, abaez, TAW, Kevmaster, irbodden, reneirwolf878, Lakeview Bulldog, Willie Fattballz, snakestang, xXhAppyAznXx, Lee, SpongeBobSquarePants, Toakes22, fire1811, SpawnBoy icantbeliveit, jaded t, Carpecerevisi, Have Blue, blazingace, Souprman, shwerp, bgdaddy599, Mossman, Dragoon, Goldie D Pimp, Remington
Very Bad traders. Negifo( TOTAL FRAUD $250.00) -
I would suggest that you read my Hyperframe FAQ and play close attention to the Adjusting the solenoid. You should follow that procedure to be sure that it is adjusted correctly.
Click here for Hyperframe FAQ
Hey Hitech your starting to sound like me! - AGD
Hitech is the man.... :eek: - Blennidae
The only Hitech LubricantComment
- AO: We are back from the dead... again! After an 18 day outage, we are finally alive and well. Who knew how complicated updating software/databases from 2008 would be. I still have alot of tweaks to make, but my main goal was getting everything patched and updated to 2026. Vbulletin 6 has changed alot since 2008 so we will have a ton of new features to dig into.
Comment