Morlock Board Woes, **PLEASE HELP**

[IcantBelieveit]

I have the morlock board in my e-mag. O.k no problem. When i put it in tourney mode, which by default is semi-auto. O.k No problem. When in E-Mode, i pull the trigger halfway it shoots full auto with the tourney lock on. Is this a hall effect out of adjustment? of a board problem? i have tried resetting the board. and no dice

and what are all of your guys witht he board setting for the optimal performance of the e-mag

[BlackVCG]

It happens with all Morlock boards. Mine does the same thing, so I just set it so that the fire point is set such that if I push the trigger to the side with the amount of slack it has and then pull the trigger, it won't go into the FA mode. Do that pushing it to both sides and you shouldn't be able to pull it and hit the "FA Mode" unless you try to pull the trigger really slow.

For settings, I use double solenoid mode because I use my Warp as the second solenoid, but if you are just using it for your gun and no accessories, set it so that it's in single solenoid mode, set registry 3 to exactly 25ms, set registry 6 to exactly 50ms.

Go here if you haven't looked at this yet:

http://www.exarin.com/products/morlockman.html

[IcantBelieveit]

i am a little confused as to how you want me to adjust the trigger. can you maybe clarify it for me, i have the TL63 trigger also

[BlackVCG]

Take your index finger and thumb and hold the trigger down at the bottom on the sides of the trigger. Push it all the way to one side and then push it back to make it fire. If it goes FA pushing it to either side and then pulling it. You have the magnet too far away from the frame. You need to set your fire point sooner in the stroke. Screw the magnet so it goes closer to the frame and then try again. It should fire one shot being pushed to either side and it shouldn't miss shots or go FA.