BigBig chopping problem Help!!!!!

[Mag89]

When I was playing paintball this saturday I chopped every game I played. List some things that might be wrong with my mag or what I am doing wrong?

[MikeCouves]

Can you give us some more details so we can help you better? Like where where you chopping? In the breech? Barrel? In the air? Stuff like that will help.

[MagNumPI]

Barrel: You might have a scratch or pit in the barrel , or mabey some dirt.

Breach: Your bolt might have some dirt on it or mabey a bur.

You could be chopping balls cause of short stroking it. Paint could be deformed and very brittle..

Or your gun is dirty.. were you running then you fell and harpooned the gun into the ground (this one time this guy was running and he triped , he fell is barrel stuck into the ground and he kept on rolling , his gun was jammed into the ground, totaly messed up his Dye boomer.. ) That stuff happens.. you know if your a player or just a casual player , when you fall your gun never hits..

Thats all i got to say , Good night and god bless ... ??

[Drizit]

check your nubbin.
also you may be out shooting your hopper. try a 12V rev.

[Mag89]

I was chopping only when I rapid fired. The paint was in the feed tube or the part where the elbow goes on. There was also paint in the barrel, but hardly ever on the bolt.

[a_malfunction]

Were you short stroking? I also read your sig, it says you have a 9v rev, perhaps you were out-shooting it.

[kenshinkandon]

Blow Back

In your sig you say you have a standard feed. When you rapid fire there maybe air escaping around the bolt and forcing the balls in your feed tube to hop up. Therefore when you pull the trigger again the next ball in the feed tube does not have enough time to land into the chamber fully. Try slowing your rate of fire or try a long nose bolt from AGD.

Sorry didn't see your last post check your hopper and try a new elbow look in your hopper to see if you can find any jagged edges that may be breaking your balls in the hopper.