X-Mag A.C.E. Warp problem

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • sevenlevel
    Registered User
    • Jul 2003
    • 10
    #1

    X-Mag A.C.E. Warp problem

    I have attached a Warp feed to my new X-Mag using the Airgun Designs signal wire. The warp is not turning when either A.C.E. mode 1 or 2 is selected, it will only work with it turned off. The jumper in the Warp is currently set to sense vibration, this is the only way it will work with the ACE mode on. Has anyone come across this before?
    Tags: None
    • bsolomon
      Mr. Excitement
      • Jan 2002
      • 126
      #2
      Drop a PM to RobAGD - I'll bet he can get you headed in the right direction.

        Comment

        • BlackVCG
          Grubby Owner

          • Oct 2000
          • 4956
          #3
          Do you also have a jumper set for + input signal? You should have a jumper in the middle slot and one in the bottom slot (vibration).

          If that's all set right, it shouldn't have a problem.
          My Feedback

            Comment

            • sevenlevel
              Registered User
              • Jul 2003
              • 10
              #4
              It was originally set to +5 signal only (no vibration jumper was set). I now have it configured for vibration only as it seems to work well in ACE & non ACE modes. I would have thought that the signal wire was the more reliable of the two methods, but since I still can't get a pulse in ACE mode it seems pointless to configure it that way.

                Comment

                • sevenlevel
                  Registered User
                  • Jul 2003
                  • 10
                  #5
                  BSOLOMON, how do you have your warp jumpers set to work with your X-Mag? Do you have a Warp to gun cable installed? I have tried every configuration possible and have not been able to get the Warp to work off of the trigger pulse only when the ACE is turned on. With the ACE off the signal wire setup works great. I'll use the vibration sense if I have to...

                    Comment

                    • bsolomon
                      Mr. Excitement
                      • Jan 2002
                      • 126
                      #6
                      My gear, including my X-Mag is making the Fedex trip back from the east coast this week (too many problems attempting to fly with paintball gear anymore). Once it gets back I'll take a look and let you know the settings, but it is wired to the X-Mag for both sensing (intelli-feed) and power. The setup on the marker was originally done by Rob Hoover (RobAGD) which is why I suggested that you send him a PM (private message). Or, you can call him. He works at Pev's Paintball. You can find the phone numbers at www.pevs.com. He is usually at either the Fairfax or Streling store.

                        Comment

                        • sevenlevel
                          Registered User
                          • Jul 2003
                          • 10
                          #7
                          I contacted him and he suggested that I set it up for vibration and sense wire. I suspect though that since it doesn't work with sense only then when I set it up for both that it's actually working of the vibration part. When I have more time I plan to attach a volt meter to the sense wire to see if I get a pulse there in combination mode. Thanks...

                            Comment

                            Previous template Next
                            Working...