I need some serious help

[ElementEclipse]

Hi, i have a huge problem, my gun won't fire. My valve is fine, i just put a new rebuild kit on it, and i put it on my friends mag and it fired fine. Then i put his valve on my gun, but it won't fire, when i pull the trigger it just makes a farting noise, someone please help me, i really need help badly, i don't know what to do:-(

[SGTKennedy]

my only guess is you have a bad sear, not much else could malfunction in the body.

[MAGS own YOU]

You know what

I am very used to that noise. That frmmmhff noise. It would do that no matter how much i pulled the trigger. It has to be your trigger sear. This happened to me as well. I had to replace my on-off valve and trigger sear.

[aztecminds]

Check the trigger rod length and the sear for wear. Mabye grip frame is not set up properly? Just a guess?

[PyRo]

Pt spacers, trigger rod leangth (should be 1.985), badly worn sear or bolt.

[ElementEclipse]

thanks guys i really appreciate your help, i think that is the only thing it can be, cuz i have checked and or replaced everything else on the darn thing but the sear, it must be that. i really appreciate your help.

[PyRo]

If you have dial capipers, the trigger rod is probably the first thing that you should check. Try differant PT spacers too if you have them. Just to save yourself the money for a sear incase thats not the problem.

[ElementEclipse]

how much for a new sear?

[PyRo]

The price is listed on www.airgun.com with all of the other parts. Something like $20+shipping. This price could vary at differant websites and shops though.

[ElementEclipse]

ok thanks, so the only thing oyu guys think can be wrong withi ti s the sear?

[PyRo]

What have i said a few times before Pt spacers, trigger rod leanth, could effect it.

[n1mr0d]

actually that happened to me one time when i put screws that were too long for the frame into the grips....it stuck the sear and the gun would just fart......


take the grips off and make sure the sear is moving properly.

[ElementEclipse]

that happend when i first put my stickies on it, i think what it was was after i got it my bestest friend decided he ws gonna give me a " mad fly trigger pull " and decided to screw with the lenghth of the sear rod, well result of letting my dumb friend screw with my gun, i get screwed, and my gun doesn't work, does anyone know how to tell where the sear rod lenghth SHOULD be? Thanks a lot

[Ityl]

sounds like the rod needs to be unscrewed a lil. I'm not sure the exact length, but it's something like 1.9

[ElementEclipse]

1.9 what, mm, cm, inches?