Need A lot of help! Automag rt!!

[RSUAVE911]

For some reason my gun is not accepting the balls right...Like it shoots very fast on just gas but as soon as I add the hopper(definitely not the hopper tried adding balls manualy)..It will not fire anymore than like 1 ball at a time i would have to like shake it to have it get in the right position...and i know my barrel is in the right place....thanks for your help!

[BlackVCG]

Hmm... sounds like your feed plug is hindering the ball flow. Do you know if you have the parabolic PF plug? It has two set screw holes on the ends of the handle you turn it with. You need to make sure that the PF plug only hangs over the edge of the breech hole by about 1/16" If it it's too far in, balls will hang on it and not feeding in as fast as they should. If you do have the parabolic PF plug and it's too far in, screw in both set screws an equal amount until it's backed out far enough. Easiest way to do this is back out the feed plug until you see metal at the bottom of the curve of the PF plug when it's in position so balls can feed. Then back out the set screws just past the point that it covers up the lip. Try this and let me know how it goes.

[RSUAVE911]

Ok thanks a lot..That is basically what I thought..I figured something was like stopping the flow but I just didn't know what but I had no clue how to fix it...I will try it out when I get some air