i was wondering if you can put an ace eye in my micro emag and if so what do i need to do?? Also tom are u gonna sell any new boards for emags??
-
Micro Emag
benchmark dropforward
X Valve
68/3000
Revy
All Black
-
No. YOu can't really do it. You have to mill the gripframe out as well as the body. Then, you have to have the software updated. Not a project to undertake lightly. -
ACE = Anti-Chop Eye
So there is no need to say "ACE Eye" Because then you are really saying "Anti-Chop Eye Eye"
If we all converted Rate of Fire from BPS to $/Minute, we would all play stock.
Comment
-
your definetly right my bad for saying ace eye ill never do it again promise
and thanks for helpping me figure that all out kinda said though cuz x mag too much money for me 
well at least i tried
Micro Emag
benchmark dropforward
X Valve
68/3000
Revy
All Black
Comment
-
i dont know how too spell hehhehehe said
Micro Emag
benchmark dropforward
X Valve
68/3000
Revy
All Black
Comment
-
You could use an "emagnumm" Morlock board. You can get them at www.exarin.com They come with a through breach ACE. You have to drill a hole on either side of the breach centered on the feed tube. Then figure out a way to cover them so they dont get damaged.
Im going to try and install one on a spyder.
PM me for more info.Comment
Comment