Alright, here's my problem. I got my Mag up and ready to go today for the final test of the Lv. 10 bolt. I gassed it up and fired a few shots. It fired every time I pulled the trigger. I then checked the venting and everything was fine there too. Was bouncing back off a squeegee like a charm! Then, my problem appeared: The marker refused to fire after about 30-40 shots. The bolt would come forward and then return like it bounced off something mid cycle. I would continue to pull the trigger and the bolt would gradually not move at all! At this point I would normally think my tank was out of air, but my Mag did the same exact thing yesterday and I did not refill it in between. There appears to be enough pressure in the tank (I'm stuck using CO2), and there is still gas pressure on the trigger but it just "plays dead." Help! Am I missing something!?
Setup is this:
CO2 (grumble)
32 degrees remote to bottom line
ACI 6-stage expansion chamber to
Classic mag with Lv. 10 bolt apparently working.
Setup is this:
CO2 (grumble)
32 degrees remote to bottom line
ACI 6-stage expansion chamber to
Classic mag with Lv. 10 bolt apparently working.
Comment