X Valve problems
Ok, I'm not sure if this is an RT problem or a Level ten problem, but my bolt is sticking. It usually works fine when I pull the trigger at a slow rate, but when I speed up it starts to stick. Any suggestions to what might cause this? The vave is new (I've shot maybe 2 cases through it). I have used a little shocker grease on the inside of the bolt. I have the input pressure set at around 750 psi.
- AO: We are back from the dead... again! After an 18 day outage, we are finally alive and well. Who knew how complicated updating software/databases from 2008 would be. I still have alot of tweaks to make, but my main goal was getting everything patched and updated to 2026. Vbulletin 6 has changed alot since 2008 so we will have a ton of new features to dig into.
Comment