Leak PLEASE HELP

[paintballman333]

I have a tiny leak coming out of the valve, Im not sure where it is exactly (I think it might be where I put my macro-line into the 90 degree fitting you know where the fitting screws into the gun). Please tell me if anyone has had this problem and what I need to do to fix it! thanks

[Big'n slo]

Hey,

First, check to make sure you have a nice straight cut on your macroline. Then make sure you have teflon tape or blue loctite on your macro fitting's threads.

[FalconGuy016]

Follow big'nslows steps (most probable), but if they dont work, try as hard as you can to pin point where the leak sounds like its coming from. It may be that your velocity has been turned too high and it is starting to vent out the back of the valve (as a safety). Did you recently install a level 10? Or if you had one for a while, you might have been right on the edge and if you recently turned the velocity up, even a little, it might have started the safety vent out the back. If thats the case you should change to the next lowest spring, follow <a href="http://www.automags.org/resource/level10/index.shtml#detailed">this guide</a> towards the bottom under main spring tuning. If this isnt the problem though, you might have to move on to replacing seals and such inside the valve.