I have a mag with a ule body, intellaframe, evo2, and i just got an x-valve. I know that it said that the lvel 10 had to be adjusted but i just put it on and it shot fine. But today, i put it all together and started firing. the sear pin got stuck half way. it was just a little bit gunked up in the intellaframe but i was wondering if the lvel 10 had anything to do with it. also what do i need to do to my lvel 10 to tune it? Thanks
-
My Mag-Black ULE, 10in Bomstick, Evolution 2, Chrome Intellaframe, Flatline 3K, and some splash eclipse parts, also an x-valve......HOT DAMN!!! -
Most of the Xvalves I have seen have been shipping with a carrier thats way too tight. You are probably getting boltstick. Go to a lerger carrier with the same oring and try that. It needs to be a barely snug fit.
Comment