Xmag problems?

[CoFFeY[NiTrO]]

I just turned on my Xmag and I pulled the trigger and the solenoid clicked, then I tried to cycle through the things, like TS SPS ACE etc. and the screen like poops out. The battery acts like its out, like the message ACE screen tried to come up, but it just dies out like it can't do it. I charged the battery earlier today for an hour, even though it didnt say low battery, I just want it to be ready for tomorrow. The only thing I could think of is that I was adjusting the trigger magnet. I don't know if this has anything to do with it, but that is the only thing I have adjusted on the gun since I got it from AGD.

[fire1811]

actually i think if you have the magnet two close to the sensor it does do this im not possitive
but try backing it out a little i think it will solve your problem

[CoFFeY[NiTrO]]

Yeah, my bad, I'm just a moron that doesnt know how to adjust a trigger :P.

[fire1811]

did it work??
man i hope so that would make me feel all special

[CoFFeY[NiTrO]]

yup.

[dcmander]

Is this the reason your gun wouldn't fire at your tournamnet??

[cphilip]

yes I would like to know that too..

Also you reported that it did not work in manual mode. Now Is that still the case. I mean full manual with power switch off and turned to E mode?

And if so then did the Trigger rod go tight? Was there pressure to the rod?

Need some more diagnostic information in order to help you on this.