hot to put x valve in microemag

[MicroEmag]

hey i was wondering what i need to do to switch my xvalve into my micro emag
Thx

[Dayspring]

Save the on/off assembly. Put Xvalve in.

Done.



(You may need to tune the level 10, you may not.)

[MicroEmag]

hrmm feeling very dum today where is on/off located
thx again

[yurchikcs]

Inside the valve. Pull the valve from the gun, flip it upside down, and it will be right there sticking out the bottom. It's were the sear pushes against.

[Dayspring]

Take the little pin inside it too.

[ignatz]

MicroEMag - If you bring your marker out to Paintball Experience this weekend, I'll show you how to do it if you like. Specifcially, the parts you're interested in are the on/off pin and the quad-oring from your Micro E valve. Take a look at the diagram: here Trade those two pieces with the X's and you'll be in business.

[MicroEmag]

allright i think im done except lnow you tell me i need a different o ring witch is the quad oring??

[ignatz]

If you are simply upgrading a Micro EMag valve to a X Valve, you shouldn't need any new parts. If you don't have the old valve, you will need 2 parts a> a PTP Micro EMag on/off pin (The MicroE's on/off pin is a different length that the normal EMag's) and b> a quad o-ring. (In the exploded RT Valve diagram, the o-ring on top of the on/off assembly is typical but the E's require a slightly different oring.) Did I answer your question?