ULE Body and retro valve

[IanC]

Quick one here people, just got my new ule body and I can't seem to get the valve to run properly. Tried changing on / off pins and it still won't run properly. To long and it jams a ball in the feed neck but lvl 10 doesn't bounce, too short and it goes fully auto.

I've tried putting the old standard valve in and it just won't fire! I think i may have the wrong sear.

Which kind of sear do I need for a retro valve, on a standard rail with a ULE body? Currently its running a standard one from a classic mag.

Please help as this is really pi$$ing me off

Thanks

Ian
:)

[athomas]

The standard sear that you use in your rail will work for both the standard valve and the retro valve.

If the short pin causes full auto then use the longer one. The retro should use the .750" on/off pin length.

If the level 10 bolt jams balls and won't reset, then add a shim or two until it vents properly on any jam.

I take it that the entire setup was working when you had the original steel body on the gun?