Im having problems installing this

[MAGS own YOU]

I cant install the reactor on off valve, Im not sure what to do, and these directions are not in english. I cant firgure out what goes first or last. Please help me!

[MAGS own YOU]

I really need help. I cant figure this out, and i no longer have my stock on off vavle. Plesae any advice

[Phatty]

Well, aftermarket internals are a NO NO, but I'll still help ya out. Take out your on/off. As i recall, the reactor is just the top right? Well, take a good look how all the orings are placed with everything stock, take off the top, put on the reactor, and put her back in. Should work fine.

[MAGS own YOU]

It claims it is the full- on off valve, it comes with a little circular metal piece and Im not sure if i put the reactor valve with the skinny part down or up. Its getting my angry

[MAGS own YOU]

Cmon please, it says to put the o ring set on top of the valve when it is in, i translated it. IS this right, will it work this way?

[alf]

i would think this means, put the orings in first, then the on/off top, then the on/off bottom with the on/off pin in the on/off bottom

-alf

[IAN]

I'll Help Because I have One

1.First the two O rings go in first (the small white one in the slightly larger one).

2.Next the reactor top (larger metal piece)This piece goes in with the hole ontop of the o rings.

3.Two more O rings yellow and white

4.Reactor bottom (small metal disk)

5.ON/Off pin

6.While holding your A.I.R valve upside down slide it into the main body (otherwise the bottom part will fall out)

Don't listen to anybody the Reactor valve is great for cold weather so go out and have fun

[MAGS own YOU]

Thank you very much

Thanks alot IAN!