Cocker Question?

[Demobilized]

I just got a new FBM body, and the ball chamber(? or where the ball sits before the bolt pushes it into the barrel) is rather tight on the paintballs. It can be pushed through but with a little force. I was just wondering if this will affect my perforamce.

By the way the chamber is smaller than the stock chamber.

[jimmyjobob]

.

are you referring to the feed tube?

what paint are you using. that could be your problem. overall, if the paint cant feed smoothly through here, then yes i would think this would be a problem.

[Nobody077]

I havent ever used a FBM body but I would find a way to call/E-mail them and see if the body is ment to be smaller in that area, or if you got a flawed body. If the balls fit to snugly in the chamber then you will probaly get more bolt-barrel brakes than you would with a larger area. Or this may be the way they designed the body, it would work as a built in ball detent.

[Demobilized]

The body has a detent hole drilled, and the balls fall out of my stock 2k body. But when I tried to slid them through the FBM body it gets stuck and can only be pushed out. No not the feedtube, its what the feedtube feeds into . Ill call them tomorrow.