Im using a revy with my warp and Im having problems keeping it on there. The neck is just small enough to not fit in the warp snug. I tried electric tape (cause thats all i had at the field) and it kinda worked, but i want a permanent solution. what do you guys use?
-
-
Dye makes a feedneck spacer. You insert it into the Revvy feedneck and then put the Revvy in the Warp. Works like a charm. -
the easiest thing to do is to back the screws out of your warp a bit so that there is a slight gap betweent the halves, then wrap enough tape on the neck of your loader so that it is a tight fit. Then, tighten the screws back down with he loader in place. Very cheap, very easy and no increased profile."[T]he evidence also strongly suggests that neither Billy nor Adam could have invented what is claimed."
-United States District Court judge G.M. King,
on Smart Parts' patent claim, August 23rd, 2004, page 16.
AO feedback
ebay feedbackComment
-
the easiest thing to do is to back the screws out of your warp a bit so that their is a slight gap betweent the halves, then wrap enough tape on the neck of your loader so that it is a tight fit. Then, tighten the screws back down with he loader in place. Very cheap, very easy and no increased profile."[T]he evidence also strongly suggests that neither Billy nor Adam could have invented what is claimed."
-United States District Court judge G.M. King,
on Smart Parts' patent claim, August 23rd, 2004, page 16.
AO feedback
ebay feedbackComment
Comment