Spyder intelifeed?

[Star_Base_CGI]

Anyone have any ideas on how to pull a low gain signal off a board for an intelifeed signal?

[danheneise]

ok on my black dragun, looks the same as yours, i just found the black and white wires going from the trigger switch to the board and located where their plugged in on the board, then i took just some plain wires from an electronics kit i have and just stuck them in where the black and white wires go in and then taped them in place with electrical tape, then did the same on my hopper, just make sure you have + matched to + and - to - other wise it won't work, i don't think you could damage anything in there with simple wires so just kinda move things around, mine works beutifully.

[Star_Base_CGI]

Most excellent work.
Would probably work on other.

The switch is just a continiuty sensor for the IC.

Thanks!