Hmm this was bad =/

[MAGS own YOU]

I had the absolute worst day paintballing today! I didnt even get to play. Last week, My on-off bottom fell out and lost it, so I ordered a reactor valve, you know, to try it out. So I get it and install it, and today i gass it up and shoot. It makes that farting noise, so, i tried different combinations with it in the on-off place, and one time, i got it to shoot normal. It took about 7 seconds to recharge to be able to shoot normal like this. There was no way i could play like this, so i put the thing back in normal, and gassed it up, there was a small leak between the reg and the main valve. WHen i shot again, it burst out air in that same spot. I am really mad cuz i couldnt play today. Can yall just tell me all the parts I should get to be safe and repair this thing. I really think i should get a parts kit. BTY this is on the stock 68 Automag valve. Too bad my retro was getting worked on. grrrr

[X-Plosive]

That's really something I would need infront of me to fix because I have no idea what configuration is on there right now.

[MAGS own YOU]

Stock 68 Automag valve, ans venturi bolt, and phase 2. This is the reactor on-off valve.

http://www.888paintball.com/Product_Card2.asp?ItemNo=08%2D3%2DAGD+A%2FMG+RCT+VL

[MAGS own YOU]

Should I just buy a whole new stock on-off valve assembly? And a parts kit.

[Russ]

When all fails, call AGD and get an RA# (return authorization number ) You need it from them before you can send it in. They'll fix it right. They're real good like that.

[SPECK]

I have one and it has not made a difference either.

[Jaan]

The "Reactor" on/off was a fix for the original stock Level 7 on/off because they were restrictive and you would get shoot down. I never had problems with my Reactor and it was an improvement over my original, but then after I got the new(er) better designed stock on/off I put that in and it works just fine. I have heard however, that people have had a lot of problems with the Reactor on/off.

[jewie27]

I had the absolute worst day paintballing today! I didnt even get to play. Last week, My on-off bottom fell out and lost it, so I ordered a reactor valve, you know, to try it out. So I get it and install it, and today i gass it up and shoot. It makes that farting noise, so, i tried different combinations with it in the on-off place, and one time, i got it to shoot normal. It took about 7 seconds to recharge to be able to shoot normal like this. There was no way i could play like this, so i put the thing back in normal, and gassed it up, there was a small leak between the reg and the main valve. WHen i shot again, it burst out air in that same spot. I am really mad cuz i couldnt play today. Can yall just tell me all the parts I should get to be safe and repair this thing. I really think i should get a parts kit. BTY this is on the stock 68 Automag valve. Too bad my retro was getting worked on. grrrr

the problem is that you bought a aftermarket on/off, those suck major butt.

[nevets11_2003]

guys this threads 4 years old

[MoneyShot]

how do you know?

[MoneyShot]

oh haha i see, lol

[jewie27]

so...


It's just a reply. What's the problem? Don't like my answer, don't read it.