ULE feed neck removal

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • JHancock
    paint check this!
    • Aug 2003
    • 8
    #1

    ULE feed neck removal

    I want to change out the feed tube on the ULE body, but it won't move. What color loctite do they use on these? Anyone able to get one off without scratching the hell out of it please let me know.
    Tags: None
    • Dayspring
      aka- The Day Wang

      • May 2001
      • 9664
      #2
      It shouldn't be THAT tight... However, a strap wrench would do the trick. The only problem with that is you risk stripping the threads if you do it.

        Comment

        • Kevmaster
          Owners Group Div: Director
          • Oct 2001
          • 5475
          #3
          strap wrench would be the best

          and if you cant get one, putting a towel around it and thne using a bench vice should get it off with minimal scratching

            Comment

            • paintballbeaver
              SHORT BUS KILLAS
              • Jul 2002
              • 1100
              #4
              remover the detent befoer doing this
              but take a lighter and heat up the the bottom of the feed neck then use a strap wrench thats what i found to work


              i say remove the dentent because you can warp the spring and melt the delrin
              MY SIG RULZ



              GOOD TRADERS: openboater, muirtach, abaez, TAW, Kevmaster, irbodden, reneirwolf878, Lakeview Bulldog, Willie Fattballz, snakestang, xXhAppyAznXx, Lee, SpongeBobSquarePants, Toakes22, fire1811, SpawnBoy icantbeliveit, jaded t, Carpecerevisi, Have Blue, blazingace, Souprman, shwerp, bgdaddy599, Mossman, Dragoon, Goldie D Pimp, Remington

              Very Bad traders. Negifo( TOTAL FRAUD $250.00)

                Comment

                • SG Avenger
                  Accuracy Vs. Volume
                  • May 2003
                  • 286
                  #5
                  [grin] I was trying to remove my hopper the other day and realised I was unscrewing the vertical feed... DOH. It cant be THAT hard to get apart.

                    Comment

                    • bankes
                      Registered User
                      • Aug 2003
                      • 215
                      #6
                      Originally posted by SG Avenger
                      [grin] I was trying to remove my hopper the other day and realised I was unscrewing the vertical feed... DOH. It cant be THAT hard to get apart.
                      that always happens to me then i put the rise back on and i can't get it off with me hand, it is wierd.
                      MY FEEDBACK

                      -BACKMAN FOR TEAM BOX
                      --Sponsored by Stalker Paintball

                      "Originally posted by maskedpenisfromvenus
                      I'd say you were mcowned quite well. "

                        Comment

                        • JHancock
                          paint check this!
                          • Aug 2003
                          • 8
                          #7
                          Oh yeah!

                          OK, we got the neck off. First things first. Yes, it was that tight. I soaked the feed tube to the top part of the body in boiling water after I removed the ball detent (thanks for the tip paintballbeaver). Then the strap wrench worked its magic. There was a ton of red loctite on the threads (a drop or two usually works). Didn't hurt the threads a bit. Thanks for all the good advice guys. I love this forum!!!!!!!!!!

                            Comment

                            Previous template Next
                            Working...