Sear Problems
Alright guys, I have NPPL NJ in two days, lol so I need to fix this like tonight. I aired up the RTX tonight and started shooting paint when I noticed that after a few shots it starts venting kinda hard from the bolt. If I pull the trigger into the sear, like make them touch but not make them shoot, it stops the leaking. So its like this, sear with pressure= no leaking. Sear when not being fired= leaks down the barrel. Any ideas?????
-
2 da k da 2 Timmah.
Oh..it shoots da 620:1 .No problemo. -
Remove the shims from the level 10 setup.Except for the Automag in front, its usually the man behind the equipment that counts. -
ok...
gas up and hold the trigger bakc. if it leaks, you've got a on-off problem, if not, you've got a LX problem. im 95% confident its LX.
Going on that, let the leak start. stick your finger in the breech and wiggle the bolt around. does it change in noise? if so, then you've got a carrier problem. go down to a smaller carrier. if not, then remove a shim or two
Comment
-
Comment