Hey, I my freind here just got a warp feed for a verticle spyder its a agd warp but i cant figure out how to mount in on the marker? I know theres a plate that runs from where the asa used to be and its mounts on the other end of that but i cant figure out how.. if theres a site or something that shows me how to mount it that would be great.. any help helps guys thanks!
-
-
First, I believe there is a thread at the top of the Tech Support forum where you can find all the Warp info you're after.
Second, the AGD Warp only includes materials to connect it to an AGD marker. You'll need the Pro Team Products Warp adapters to make it fit right. Have a look in the Misc. For Sale forum... I'm sure you can find one there.
Hope this helps. -
Phillip...you shoulda IMed me
if its the vertical spyder tat requires the vertical elbow, then you're set. You SHOULD be able to just put the clear adapter over the vert feed and tighten it. if its too wide for the vert feed, then put a spacer in there. if its too small to go around it (and its not the vert eblow version) then get some sandpaper and sand down the clear elbow and make it so it fits inside the vert feed
Comment
Comment