Bolt sticken

[HoppysMag]

When i gas up my 68clasic and try to fire it the bolt sticks. acording to the manual its a spacer tube problem but when it sticks gas leaks out the barel and the on/ off vaulve like loosens. so wen istrip te gun the on/off vaulve falls out. and the bolt continues to stick. i think its because it needs oil so il try that but im not too sure. Please i need help post it here.


THANK YOU SO MUCH

[kickass68mag]

tech forum

try oiling it and see if that helps if not get a pt spacer kit and see if that works

[HoppysMag]

thanx

thanx il try that

[markhauguel]

Also you might try not tightening the rear frame screw as hard. I used to use an allen wrench on mine until I got a new bolt and it sticks if I tighten it more than finger tight. Good luck

[BlackVCG]

The on/off falling out isn't a problem. You might have a Reactor Valve and that's why it falls out. If it's an AGD on/off it should stay in the valve. As for the bolt stick, pull out the PT spacer you have right now and replace it with one a size larger. That should cure it. Also put 6 drops of oil in your inlet at the valve or the ASA and cycle it with the barrel off.

[Drizit]

when you are oiling it put some on the outside of the bolt, and power tube. then put some in the ASA. that should solve your problem.

one other thing to check is the latching surface on the bolt. if it's too badly mangled it will stick.