When I crew the Nitro tank into the gun, it starts to leak from the ASA and the vlalve, what can I do to fix this?
-
MY Mag Setup:
68 Automag Powerfeed
Benchmark 45 Frame
Venturi Bolt
Phase 2 Shocktech Valve
Kapp Dropforeward
Dye Boomstick -
Make sure the tank o-ring is good. Put a bit of proper airtool oil on it if it is dry. Put a couple of drops of oil in the ASA before screwing the bottle on. If the bottle o-ring is good it should stop leaking once the bottle is fully screwed into the ASA. If the valve is still leaking, dry fire the gun a few times to cycle the oil from the ASA in through the valve. Most of the time, the valve leaks will stop once the oil properly lubricates the o-rings and the o-rings get properly seated.Except for the Automag in front, its usually the man behind the equipment that counts. -
Yes, I have just finished trying that now and all I get when I shoot is a PHOOP when I pull the trigger then ssssssssss, it still leaking.
MY Mag Setup:
68 Automag Powerfeed
Benchmark 45 Frame
Venturi Bolt
Phase 2 Shocktech Valve
Kapp Dropforeward
Dye BoomstickComment
-
Where is the leak? Inside the grip, out the front, or out the back? Does it still leak when you hold the trigger in after firing?Except for the Automag in front, its usually the man behind the equipment that counts.Comment
Comment