MicroEmag Shooting in Full Auto

[mrhack636]

I purchased a MicroEmag from someone on the forums, it had some probs so i took it to my gunsmith. We finally got it working in electric mode (Rt would stick alot) my battery died on me so It tryed playing with the RT but it kept sticking about every 3rd shot. Now I put the battery back on and it wont work and we cant get it to presurize unless we screw the velocity adjustment all the way in (seems too far) then it autofires {Even in safe}

Can anyone help me? Give me suggestions?


Thanks

Dennis Tadin

[speeddemon]

Have any stars left on the valve?

[mrhack636]

o well that doesnt make me feel any better.
1 hole has been drilled where the stars r suppose to be (No stars are on it at all)

Dennis

[ignatz]

What type of tank are you using? Adjustable or Preset?
What is the output pressure of your tank?

Does the MicroE have a LX? If so, what carrier and how many shims?

What do you mean by sticking in RT mode?

The MicroE Mag the equivalent of 2 stars. It sounds like you have one left.

If I were you, I'd start by removing the battery and getting the marker to work properly in manual mode. You can find the instructions for tuning the LX in the FAQ area. Start there.

[mrhack636]

Im using an angel Air 88ci tank, yes its adjustable.
I have tryed adjusting it no help.

Whats a LX? (Sry new to microemags)

What do you mean by sticking in RT mode? (Manual mode)

It has a Level10 inside.

Thanks

Dennis

[athomas]

Re: MicroEmag Shooting in Full Auto

Check the on/off pin. It may be bent or the wrong length. It should be about .675". Its quite possible that the pin you have is a tiny bit too short even if it is the proper .675". Micro's are known to have tolerance issues. Mine wouldn't fire at all with a .712" pin but would stick and autofire with the .675" pin. I am running my emag with a regular ULE body and haven't addressed the issue since. I may buy a .712" pin and gradually file it down until it works properly.