Alright, I was playing last night and noticed that if I pulled my trigger really fast (I've got a brand new x-valve and a semi-tuned LX) that my trigger rod would come only about 1/2 of the way back to normal, basically not allowing me to shoot. It would just get stuck there and after a while it would pop back out to normal. To describe how the rod is, its the sear that I got sent with my Xvalve, and I havent messed with it so it should be to the factory set length, and it doesnt enter the trigger frame completely when I pull the trigger either. Does this sound like a level 10 issue or something?
-
Maybe someone can PM me why my sig was tampered
with when my image is below 20 kb and was 350x159.(20435 bytes/1024 bytes per kb = 19.96 kb.) -
anyone able to help me out, I'm thinking its bolt stick but I'm not that familar with the LX.
Maybe someone can PM me why my sig was tampered
with when my image is below 20 kb and was 350x159.(20435 bytes/1024 bytes per kb = 19.96 kb.) -
has the gun been cleaned inside and out? if not try cleaning the gun and oiling it lemme know if this helpedAIM: Automag68Gunner and
BigfootWithaGun
Automag with gas thru setup 279.99
Empire reloader $44.88
PMI 88ci 4500psi $210.00
X-valve 325.00
Intelliframe 113.88
The look on your face after I bunkered ur whole team,
priceless...
also got a SNIPER automag powerfeed with a dye boomstick, silence, sight and scope,and bipod its accurate enough to shoot an apple off your headComment
-
It's your level 10. I had this problem before. I was on the smallest spring, so I went up one carrier. It leaked a bit after going up one carrier...I put 6 drops of oil in the ASA and dry fired it about 200 times and the leak was gone...good to go!
If you are on the middle size spring..go down one spring size first before going up a carrier size.Comment
Comment