ule required modifcations to put on a emag

[darwin]

i am looking for getting a warpfeed ule body for my emag

from what i have noticed there needs to be something removed due to the railling. Where can i find more information on this. and is there somewhere then can do the required milling if i dont want to break anything.

[TheDuelist]

All you have to do is remove the barrel twist lock assembly. Turn the rail over and tap it out with a hammer. Mine didn't take much force to remove. After that your good to go.

[ChucktheMAGician]

That would be true if he was getting the vertical feed ULE but he will need to, or have someone mill part of his rail out, do to the angle of the feed port on the warp ULE. I would check w/ Roguefactor, he mills out emag rails to make them ULE, he could possibly remove the part you need taken out too.:)

[TheDuelist]

It helps when you thoroughly read someones post prior to responding. Thanks Chuck

[darwin]

Thanks for the response :)