I am getting an Automag RT. Is there any problems I should watch 4?
I am about to buy an Automag RT on friday te 29th. When I pick it up should I watch for anything weird about it that could cause problems? ThankU
-
ghost_on_fire -
I've had my RT's since 1998 and I haven't even had to replace an o-ring. Just make sure that you get a few drops of oil into the valve each time that you play. I also like to disassemble and clean the whole marker when I get done playing. I also lube the bolt and power tube everytime that I play. The down side is that there aren't really any aftermarket parts if it is an old skool RT. However, there really isn't a need for them either. You should be very happy with it.I'm a lefty that plays with an old school RT with H/L. I bought a warp and all is right with the world.
SocialD's feedback
SocialD's stuff for sale
Jaz Air Technologies barrels
-
Make sure you run it on Nitrogen. They don't work too well on CO2Someone took away my cool sig. *cough*mod*cough*Comment
-
Your buying used I assume.
If your buying it in person fire it over a chrono a couple times just to make sure the consistancy isnt to freaky. If it spikes back and forth like 20psi or so it probably needs a o-ring job (reg seat usally.)
Other than that not much can really go wrong with em.
And yeah, listen to paintbattler.
Have fun!Comment
-
And if it has the lvl 10 in it, make sure that the regulator piston is new since the old one , from what i read, cannot sustan the high pressure needed to operate longer spring which is softer on ball.
Make sure you et a big tank. tere's not to much efficiencyComment
-
And get an Intelli frame coz with a bit of work it will rock like a MOFO!
GazComment
Comment