please help im soo pissed

[crazymex]

alright i just bought this used minimag and like i test fired it and i gassed it up while holding down the trigger and then when i pulled the trigger it like got stuck for a second and i could hear the gas so whats goin on please help

[fire1811]

well we need some info to help you

i would assume that it is a level 10 bolt

if thats the case then did you get all the extra parts for it?

[crazymex]

yes its level 10 and which extra parts i got a lil case with some extra parts if thats what u mean

[fire1811]

ok does it fire at all or everytime you pull the trigger the bolt stops?

[crazymex]

well like i pull the trigger then like i think the sear stays back for a cuple secoonds cuz like the trigger goes back but like i still hear trhe gass hissing for a couple seconds and then it stops and then i pulled it again and the same thnig and i dunno about the bolt

[fire1811]

i dont suppose you could come to Country Club Paintball
tomorrow?

from the sounds of it the carrier of your level 10 is too small.

you should use the largest carrier that does not leak.

[crazymex]

well actually i just went paintballin today (i had to rent)so i dont think i could affoord to go tomarow but if i took it to bbt u think the could do it w/o puttin in new parts

[fire1811]

well its hard saying with BBT
im sure there going to charge you a labor fee
but if you get it to CCP i could give it a shot or Keith the mag tech could do it. I cant quarentee it doesnt need any new part but from the sounds of it its you level 10 and if you have the extra parts for it it wont cost ya a thing

or just go though the lvl X installation from the begining
you can find it here at AO step by Step.

but i will be at CCP at noon tomarrow

later
curt