Please Help!!!!!!!!!

[llewsirc]

I am having a problem when i fire my mag. the trigger doesnt always reset itself for the next shot. when it does this i have found that if i open the frame and push up on the trigger assembly that it will reset itself. what is wrong and how do i fix it? the only part that i havent replaced is the piece that the airline screws into on the valve. (i am not sure where to get one of these anyway) please help me i have run out of things to replace! thanks for you help
kelly

if there is anyone that lives in Colorado Springs; i am new to the area and would like find out the best place to play?

[Gunga]

Hmmm...could be that your sear is worn out, or perhaps your on/off valve pin is too short?

Here's a dumb one, but...do you have enough air pressure going into your Mag? In other words, you're not trying to use it with an empty CO2 or compressed air tank, are you?

[llewsirc]

I just got a new sear and a new on off valve. when i test it i use a new tank. is there anything else that it could be?
thanks

[Army]

Here is what I had to do;

Take your sear out of the gun. Lay a piece of fine sandpaper on the table. Lightly rub the SIDES of the sear over the sandpaper. DO NOT TOUCH ANY AREA OF THE TOP OF THE SEAR THAT CONTACTS THE BOLT OR ON/OFF PIN.

What you are doing is removing any burr that may have been left on during the manufacturing process. This burr may be rubbing against the frame slot, stopping the return of the trigger.

Good luck and BE CAREFUL!

[Temo Vryce]

This is a sure fire metheod to fix your mag.
Step 1: Make Sure your mag is registered.
Step 2: Phone AGD during buisness hours.
Step 3: Inform them that you need to send them you mag for repair work.
Step 4: Answer all their questions. Make sure you have your mag handy or atleast the serial number on it.
Step 5: Write down all the info they give you.
Step 6: Mail your Mag to AGD.
Step 7: Try not to go crazy while you're waiting for your mag to return to you.
Step 8: Praise the techs at AGD when you mag comes back working better than ever.
Step 9: Tell your friends that this is the best place to get help for mags or to even just talk to other mag users.

I hope this helps you out. Good luck with the mag.

[llewsirc]

i tried sanding down the sear and that didnt work either. i even put the old one in and still got nothing. i would like to send it back to AGD but i bought it used and was told that i counldnt do that. i really dont want to get rid of it but if it cant be fixed than i will have to. its a pimp gun though(see pic). would a electric grip fix any of these problems? thanks for everybodys help so far.........

how do you post pics?

[Gunga]

Hmmm...are you using an adjustable output tank? If so, maybe you've got your output pressure set too low?

[DarkPhoenix]

Whoever told you that AGD would not help you out, told you complete rubbish. As long as you register the gun, they would be more than willing to help you out.

[Phatty]

Was the on/off you put in a stock one? If it was an aftermarket on/off, that could be causing your problem.