Emag trigger will NOT come out

[Skoad]

I can't get thisthing out!@ i got a punch and im hammering away at the thing and its not moving at all.

I've tried both directions.....

[lamby]

There is ALOT of force that is needed to pop that pin. I uded a drill press and an upside down drill bit. I figure I prob put about 60lbs of force on it before it popped.

Give that a try, and make sure you are pushing the right way or it will only get tighter. I beleive it is circuit board down to get the pin out, but I am not for sure on this.

[bmexline]

left side of the gun down like lamby said, use a light hammer and a punch. just make sure the frame is well supported. the impact of the hammer will get it out easier than a steady pressure. mine came out rather easily this way.

[Skoad]

yea i was trying to punch it out that way the first time.

i beat on the thing with punch and hammer for a while and it didn't budge at all.

i'm afraid its gonna slip off the pin and put a huge gash out of the side of the grip.

[Skoad]

i got it out, i beat the crap out of it yesterday and today i tapped it once and it came out...



strange