WTH.. I cant get my OP over 900

[Spleen]

Alright, i just got a new tank (90/45 nitro duck mega reg) for my mag. It said it goes from 0 - 1000 psi output pressure... soo, i get it hooked up and fill the tank. Screw the tank into the reg and open the valves. The highes output pressure i can get outta the reg is 850 - 900ish. I wanna get it to around 950. Soooo.

1. Should I stick with the nitro duck, and see if it just needs to get worked in or something.

OR

2. Send the tank back to the place and go with a flatline 68/45.

I Need this operating by Oct. 1st, so im goona have to do this fast.

Thanks.

[afrankart]

I love all of AGD's products, but I would reccomend the Dynaflow before the flatline.

[sneakyhacker420]

bad guage?

full fill?

good o-rings?


and why do you need the full 1000 psi out of it anyways??

[BlackVCG]

Get a real gauge on the tank to check the output.

Replace the spring pack if you can't get it above 1000 by checking it with a real gauge.

[Spleen]

already sent it back.. got a 68/45 flatline in the mail. it was full. everything worked fine.. except it wouldnt get past 850-900ish.