Xmag e-mode malfunctioning repeatedly

[paintpiggie]

ok, here's the deal:

i charge my battery overnight, i clean my xmag completely.

come playtime, i turn it on and air it up and it shoots fine in e-mode. about 100 balls go through the barrel. then,
all of a sudden, it just stops shooting. i listen to it,
and it sounds like the solenoid isnt strong enough to pull
the sear.i dont hear the clicking. i switch it to hybrid
mode and it shoots great (a bit bouncy).

i switch it back to emode and it shoots a few then stops
again completely.

i disassemble the gun and put it back
together. but the same thing happens, it shoots fine then stops.

i know there's been threads about this before, but i couldnt
find them, so ill just re-submit the thread.

i hope this is an easy fix, someone help?

[athomas]

Check the ground connection between the circuit board and the frame. It is the screw that holds the board in the handle. Sometimes the annodize prevents a good connection. Run a tap or a wire brush into the hole and clean it out. Then put the board back into the gun and tighten the screw.

[BlackVCG]

Before you mess with that, make sure you aren't getting bolt stick. When it stops shooting, put your finger in the breech and push back on the bolt. If you hear it click you're getting bolt stick and need to increase the carrier size in your Level 10 configuration or run some oil through it.

[paintpiggie]

its not boltstick
coz i switch it to hybrid mode
and it shoots good, sometimes i have to
press it all the way that its actually manual
then it shoots just fine, i think it is
the on/off pin.

i havent had time to mess with it yet,
but thanks for the info.

maybe its the solenoid?
i just bought the thing like 2 months ago.

[BetaMax]

What spring are you using for your Level 10? I beleive I am having the same issue.

I am using the longest spring and that happens to me.. Tho when I switch to the shortest, it works fine.