Feedneck...Sorry

[Spleen]

im sure this has been asked, i searched a whole whopping page back and nothing. Soo, if for some reason a warp magically appears at my door, would it work with the ULE feedneck, or do i have to get something else?

[SocialD]

It depends on if the ProTeam Products warp shows up or the AGD warp. They are the same except the PTP comes with the adapter that you need. I think that you could purchase the adapter on the PTP website also.

[Dayspring]

On either the Vert ULE or Warp ULE, you'll need the 90* adapter. I know that the AGD Warps come with them. Not too sure about the PTP ones.

[SocialD]

I assumed that Spleen meant a vertical feed ULE body.

[xen_100]

I dont beleive that is true. on the standard ULE body it comes with a feedcup. On the warp ULE it has a feed-stem.(no cup) so the AGD kit would go on the warp ULE no problem. with standard ULE you would need to have the proteams adpater, or you would need to buy a feed-stem for the AGD adpater to clamp on to(which I think look a whole lot cleaner than the proteams adapter.)

[SocialD]

I agree. You'll need the PTP adapter with the vertical feed body. Unless, you change the feed collar to the same style as the warp ule bodies. Does AGD sell this seperately? You then can use the AGD adapter on the ule bodies on which you swapped the feed collar or the warp ule bodies. I hope that this make sense.