kyleagd emag on/off switch not working??

[bmexline]

installed in the gun, when i turn it on the display says agd 1.37 and that message stays displayed instead of clearing after a few seconds. when i pull the trigger, the display goes out and agd 1.37 comes back when i release the trigger. the gun does not try to fire with a trigger pull. sounds like a short in the switch assembly itself to me.

any suggestions?

[athomas]

Try adjusting your trigger magnet. It may be too close the the HES.

[bmexline]

thanks for the suggestion, but if i remove the switch and wire it back up w/ the stock wire it works fine. when the magnet is too close to the hes it usually prevents the gun from turning on at all.

appreciate the thought.