My warp feed is like dead. I put a new battery in it and tested out other batteries It won't work, its as if the power is not getting to it at all.. Could it be the board?
-
Moo? -
Check the battery clip or the wires going to the board, they mightve snapped off, its not likely you fried your board but check for any burn marks lol- AGD "Yea well our intention is to
take over the world....one country at a time..... :)" - Rt Pro X Valved Warp fed My Rtp
- Props to Echo for the sig
- AGD "Yea well our intention is to
-
Thanks, I checked my wires. They seem to be fine except the black one has 2 little dents on it.. I wonder if this could be the problem? I should visit radio shack and get a new wire if thats the problem.Moo?Comment
-
hmm how bad is the dent? is it enought to snap/cut the copper wiring inside the wire? check your board for any fried connections check your jumpers dwell settings and the 3 black connection thingys is everything on tight? nothing loose? check it out thats it for now- AGD "Yea well our intention is to
take over the world....one country at a time..... :)" - Rt Pro X Valved Warp fed My Rtp
- Props to Echo for the sig
Comment
- AGD "Yea well our intention is to
-
Alright, I found the problem. Its the 9 volt battery wire.. How do I replace them? I bought a pack of extra 9 volt battery connectors but how do i connect them on the board?Moo?Comment
-
You could just cut the wire above the break in the old wire. The correct way to do it is to solder them on the bored though. Its been too long since I looked at my warp so I don't know how hard it would be. I think I did my wires and soldered them in but i'm not 100% sure. You would get the old ones out by heating up the solder probably with a solder gun and pulling them out.
Comment
Comment