I have a rt mag that has an Emag valve and lvl 10 kit in it and an intelliframe. What would it take to change it to a emag with full auto capibalities??
-
Full auto? you don't need an Emag for that. You already have the RT valving. Turn up your input pressure on your tank (if you have an adustable tank) and you can get it doing 22bps like that. Check my video "Wanna Race?" in my sig. That is a mechanical RT Pro with no mods or extra stuff added onto it. -
The other alternative is to buy a hyperframe. Those can go full-auto, I believe. Turning it into an emag would cost about as much as just buying an emag.Comment
-
You would have to get the following to change an RT to an emag
Emag Grip Frame and grips
Emag Board
Selenoid
Emag Sear with Selenoid Plunger
HES and HES covers
Emag rail
a few (one at least) Rare earth Magnets
Battery and Battery case
*And do some wireing runs and soldering
You could use these things off your RT in this conversion
Valve Assembly with bolt&spring and level 10 if you got it
Body & Barrel
Sear Pin
Field strip and Grip Frame screw
Rail bushing
*depending on body type and if you can get it out intact the twist lock assembly could be used.
Not worth it huh?
Comment
Comment