-
-
The bumper absorbs the impact of the bolt returning after firing. You don't want to get rid of this. The wave spring should comfortably fit arount the ouside of the bumper. The bumper will act as a centering washer. and recoil absorbing device.
The wave spring holds the bolt forward to prevent the sear from catching and the on/off pin from allowing the front chamber to recharge. Its not really bolt stick, but it acts the same.
Putting a smaller spacer in will get real bolt stick. This will make your trigger pull a lot less crisp as well.
I would check you wave spring to see if it is the proper one or if it is weak.Last edited by athomas; 09-25-2003, 03:36 PM.Except for the Automag in front, its usually the man behind the equipment that counts. -
on my pumpmag i use a clear rt bumper. i had tryed everything else including cutting down a blue one. the clear worked the best for me.Originally posted by dano_____Comment
- AO: We are back from the dead... again! After an 18 day outage, we are finally alive and well. Who knew how complicated updating software/databases from 2008 would be. I still have alot of tweaks to make, but my main goal was getting everything patched and updated to 2026. Vbulletin 6 has changed alot since 2008 so we will have a ton of new features to dig into.
Comment