R/T Mag shootdown trouble

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • g3750
    Registered User
    • Sep 2003
    • 12

    #1

    R/T Mag shootdown trouble

    My friend has an R/T mag fairly new
    The marker has flatline setup 700+ psi
    the gun shoots fine for about 4-6 shots then has major drop off and the bolt no longer recoils
    If you leave the gun alone ofr a minute or so it is back to the shoot fine a few shos then shoot down again.
    The flatline is new to the system.
    To test we took off and went back to preset N2
    same issue with drop off.
    R/T X valve was AGD installed as well as parts on gun
    Minimag
    ULE Body
    ULT kit
    X Valve
    Lvl X
    Intellitrigger
    Wood Grips
    Evo II Loader
    Omega Handle
    Shocktech Drop
    MaxFlo 4500
    12" Armson Barrel
    12" J&J Barrel Kit
  • athomas
    Of course it works-its AGD
    • Jan 2002
    • 8039

    #2
    I'd say do a good cleaning of the regulator and internals of the gun.
    Except for the Automag in front, its usually the man behind the equipment that counts.

    Comment

    • g3750
      Registered User
      • Sep 2003
      • 12

      #3
      yeah we did that. Found the problem there was a sliver of metal in the valve body. Gun shoots grea now.
      Minimag
      ULE Body
      ULT kit
      X Valve
      Lvl X
      Intellitrigger
      Wood Grips
      Evo II Loader
      Omega Handle
      Shocktech Drop
      MaxFlo 4500
      12" Armson Barrel
      12" J&J Barrel Kit

      Comment

      • athomas
        Of course it works-its AGD
        • Jan 2002
        • 8039

        #4
        Yep, a piece of dirt is one of the major causes for fluctuations or erratic behavior in a mag. That's why we always recomend a good cleaning before all else.
        Except for the Automag in front, its usually the man behind the equipment that counts.

        Comment

        Working...