Xmag...Stop shooting in electronic!!!

[G-Rock]

Well it ahs been happening more often here lately.

I will be cranking away on the Xmag in electronic, and it will just stop shooting. I will then throw it in manual and shoot one shot and put it back in electronic and it will work fine for awhile until it stops again, do the same thing throw it in manual and shoot, and then in electronic and then fine.

What is up, and how can I fix it??

Chris Geiger

[paintpiggie]

Take the on/off pin out and lube the living **** out of it.

[Schnitzel]

could be related to your hall effect sensor.

try backing your magnet out a 1/4 turn and see if that helps.

[BlackVCG]

Sounds like bolt stick to me.

Increase the LX carrier o-ring size by 0.5 with the SAME o-ring and see if it leaks. If it doesn't, then use that setup.

Also, as previously mentioned, a dirty on/off pin and on/off pin center o-ring will sometimes make the solenoid not able to trip the sear.

[Potatoboy]

take the grip cover off, and check if the clevis/solenoid plunger assy is perfectly straight. if it isn't, straighten it, and it should work fine...

[bunkerhugger]

Originally posted by BlackVCG
Sounds like bolt stick to me.

Increase the LX carrier o-ring size by 0.5 with the SAME o-ring and see if it leaks. If it doesn't, then use that setup.

Ditto.

If you leak try polishing up the bolt stem a bit.