My emag does not shoot in electro mode unless I push the trigger forward after I have completed one shot. When I push it forward it doesn't even look like it moves forward anymore but it must because it shoots after I do that. I'm thinking that it has something to do with the sensors and possibly the magnets. I would appreciate any suggestions and comments. I will check back often for replies. I am anxious to figure out the problem and will respond to any curious questions. Thanks, Ian
-
Play P8ntball! -
you need to use the set screw in the middle of the trigger
right on the hump turn it slowly till gun fires reliably"The Few Who Do Are The Envy Of The Many Who Only Stand And Watch"
Alway Remember *343*
Si vis pacem, para bellum -
Try adjusting the magnet in the center of the trigger by "unscrewing" it so it recesses itself into the trigger more. This will move the firing point closer to the frame and you won't have to pull the trigger all the way forward to get it to reset.
Also, the magnet in the top of your trigger might be coming loose. Pull the trigger a bunch of times in E-Mode and then put the gun in manual mode and pull it and look at the magnet at the top of the trigger. If it looks like it's coming out of the trigger and it's not fully recessed into the trigger, then it needs to be reglued.Comment
Comment