X Valve into Emag ??

[rmhawk]

what must be done to place my X valve into my Emag?? Switch on/off's or just pins?? what problems may i encounter??

[maglover52]

switch on/off

[rmhawk]

[Kevmaster]

when you trade in valves, or get the x-valve...keep the emag on-off pin and put that into the x-valve and then install the x-valve. aside from LX and velocity, you should be set to rock!

[Schnitzel]

dont forget the black quad oring form the emag valve as well.

[rmhawk]

thanks for the help guys. my emag gets here today i will see what happens

[abunkerer]

i just had this problem...

I just had this problem myself, I swapped the e-valve for the x-valve but didnt switch the on/off's...the gun worked but would cough" every now and then...So I got some advice from the great minds of AO (thanks guys) and swapped the pin assemblies, The gun didn't work at all after that...I forgot to swap the big o-ring as well -the one that sits in the valve, and a smaller one fits intide of it- So now it is fixed and everything is right in the world. moral of the story: When putting an x-valve on your emag swap the entire on/off assembly and all of the orings associated with it, or else it will not work right.