i picked up a used Hyperflow 68ci 3k adjustable output non-screw in tank for my Emag last week. I gassed it up today, no probs, but the gauge said 500psi, not quite what i needed so i turned it up, when it got to about 700PSI it started violently leaking out of the adjusting nut, so i backed it out, no leak. So obviously i cant get the 800psi i need, any idea how to fix this problem? Is there a part i need purchase and swap out?
Centerflag Hyperflow NEED HELP!
Collapse
X
-
Tags: None
-
it's not the end of the world, all the problem is an o-ring failure... prolly not the reg pin. you can go to Fox Paintball in Dundee on rt. 31 for a rebuild kit most likely, or contact Centerflag directly.
Personally, that is one problem I haven't had on my Hyperflow regs.
-
That would cause it to leak at 700psi and not 500-600psi? Wouldnt a failure make it leak always? I would go to fox but I dont like getting overcharged, usually cheaper for me to buy somehting and have it shipped than to go to fox. If that is the case, ill call centeflag on monday and see what they say.
Comment
-
yeah cause when its not leaking my emag wont fire well, which confirms its under 800psi
Comment
-
I looked all over onlnie for a rebuild kit, no luck? anyone know where to get one? Maybe someone has an extra? Should i just call centerflag aobut this?
Comment
-
foxriver paintball usually has all of centerflags products
call them
look there for there ##"The Few Who Do Are The Envy Of The Many Who Only Stand And Watch"

Alway Remember *343*
Si vis pacem, para bellum
Comment
-
Ok i guess i will end up at fox, lol. Thanks for the input
Comment

Comment