trigger block

[batteryfree]

hey what can i use as a trigger block, or can i actully buy a trigger block. or what can i do to lower my trigger pull length?

[athomas]

Most people use a set screw either behind the trigger or behind the sear where it attaches to the trigger rod.

If you do use a trigger stop, make sure you allow enough distance past the firing point to ensure the gun fires reliably each time.

[batteryfree]

could i shorten my trigger rod to teh point where it still fires. and would that shorten my triger pull

[athomas]

The trigger rod pushes the sear. Its the sear that actually performs the operation of closing the on/off pin and releasing the bolt. Since the sear is a fixed object, you can't change it. By shortening the trigger rod, all you are doing is moving the trigger contact point back farther. The actual moveable distance remains the same. The problem with shortening the trigger rod is that you may make contact with the handle of the trigger frame before the gun fires.

[batteryfree]

but the fires even tho i dont pull teh trigger back all teh way, so couls i just shorten it untill teh point where it reaches contact to teh frame and fire, just tinker with it.

[athomas]

I don't think that would be a problem. Make sure the trigger has some movement past the firing point before it stops. This will ensure consistent operation.

[RRfireblade]

Originally posted by batteryfree
but the fires even tho i dont pull teh trigger back all teh way, so couls i just shorten it untill teh point where it reaches contact to teh frame and fire, just tinker with it.

That'll give a ton of pre-pull slop.Your better off to keep the rod adjusted correctly and put a stop point after it fires.

Jay.

[PyRo]

Your trigger rod is factory set to 1.985in, now if they measure it to the 1000th of an inch do you really want to screw with it?

[batteryfree]

has anyoen here ever used a trigger block or any sort of tricked out trigger. if anyoen does do they have any pictures or movies to show it.

[batteryfree]

and fireblade, i think i am gunna do that it sound liek a good idea, but i want osme pics of anyoen who has done a trigger job.

[68 Mag]

Battery-

I was working on my Benchmark 2 finger and the rod.

I turned the rod out (yes, I lengthened it) until it was about 1/16 off the back of the trigger. Now, the trigger will fire with the safety on, and uses the safety as a rear travel limiter.

However! This WILL render the safety USELESS as an actual SAFETY! Get in the habit of coming off the field and turning off your powerfeed and/ or tank when you put your barrel blocker on, and learn to keep your fingers out of the trigger guard. That way, if you do accidentally pull the trigger, at most it will shoot air or shoot nothing, if your tank is off.

But I am not responsible for anything you mess up while trying this. It's not sanctioned by AGD (I dont beileve it is, anyway) and therefore not supported by me. You break it, it's your fault. Dont blame me.

[SpdElemts]

How do i take out my trigger out of my DYE trigger frame?

Thanks

[PyRo]

Its not sanctioned by AGD for a reason
There is a pin holding it in, just use somthing to knock if out. I think it comes out left-right, but i'm not sure. If one side of the pin is bigger than the other that side comes out first.

[batteryfree]

so the trigger pull as like frikin tiny??? damn that sounds cool.